iLoveToCreate Retrofabulous Crafts: Sparkletastic Easter Earrings!

Sparkletastic Easter Earrings
iLoveToCreate Retrofabulous Crafts
Copyright Margot Potter
“These ARE your grandmother’s crafts...ya gotta problem with that?”

From McCall's Needlework and Crafts 1968

I have been toying with making a pair of sparkly Styrofoam earbobs for a while now. There are endless variations on this idea in my stash of vintage craft magazines. They’re also made of cork and wood...I’ve even seen these made of crumpled aluminum foil. The idea is to suspend a round ball on a thin chain for a pair of swingy earrings. Remember that these are styrofoam, so they weigh almost nothing, but if you like a more delicate silhouette, feel free to use smaller balls. I like my jewelry big and bold. These would be perfect for a teacher, young mom or if you’re feeling cheeky, to sport to the family Easter dinner. I’d make a matching necklace and wear this out and about just for fun, but I’m not afraid to be noticed.

Take this idea wherever you like, add sequins, seed beads, rhinestones. A splash of glitter gives it a little sparkle and the sparkly rick rack trim immediately evokes Easter eggs. I’m of the mind that life is short, so have a little fun now and then. What could be more fun than pink sparkly Styrofoam earbobs?!

Materials
2 1.5” Styrofoam balls
Sparkly silver rick rack trim
2 2” head pins
2 matching beads to secure headpins
2 ear wires
2 1” segments of thin chain
Aleene’s Foamtastic Glue
Crafty Chica Little Paints in red and white
Crafty Chica glitter in pink
Craft wire for painting and drying balls
Styrofoam block for drying balls

Tools
Chain nose pliers
Round nose pliers
Flush cutters
Foam brush
Scissors

Insert a 5-6” segment of craft wire into each Styrofoam ball. Mix red and white paints to make hot pink. Use a foam brush to pounce pink paint on surface of ball. Sprinkle glitter on ball and shake off excess. You will probably have to go back in for a second coat to hit any spots that aren’t fully covered, if you repaint make sure to re-glitter. Allow to dry, inserting wire into Styrofoam block.  Keep ball on wire. Run a bead of Aleene’s Foamtastic glue along rick rack trim. Wrap trim around center of ball. Insert back into block and allow to dry.

When glue is dry, GENTLY thread a beaded headpin into the center bottom of your ball and thread to the center top. Make sure pin is straight and take your time.  Bend wire at a 90 degree angle using chain nose pliers. Cut to 1/4” with wire cutters. Grasp end of wire with round nose pliers and CAREFULLY turn into a loop. Open loop to add chains using chain nose pliers.

Cut chains and thread on open end of loop. Use chain nose pliers to secure closed.  Use chain nose pliers to attach earring wires to top of chain.

Optional: Add a beehive, tiara and a pair of cat eye glasses...hee.